ZRPi-1NSB case: RPi 3B+ ZUMspot or JUMBOspot & 2.4"Nextion(no components incl)

Description

For Raspberry Pi 3B+, 3B, 2B, and B+ (not included), ZUMspot or JUMBOspot or N5BOC Lonestar Board (not included), and 2.4″ Enhanced Nextion screen (not included).
Case can fit a ZUMspot OR JumboSPOT or N5BOC Lonestar Board (not included)
Designed to fit 2.4″ Enhanced Nextion screen
Heatsinks and rubber feet included
*Please note that connecting the Nextion screen to your set-up may require additional soldering of pins or wires not covered in these case instructions.
Stainless steel hardware
The new inner layers have been designed to fit the Pimoroni Fan Shim (not included, available from Pimoroni)
The case kit is designed to fit the Nextion Enhanced NX3224K024 (not included) is a powerful 2.4″ HMI TFT display, with 16MB Flash data storage space, 1024 byte EEPROM, and 3584 byte RAM:
supports built-in RTC
supports save data to Flash
supports GPIO
larger CPU clock
larger flash capacity
Notes on fit of Pimoroni Fan Shim (not included):
The fan shim has been tested to work with the Zumspot versions 0.4, 0.5, 0.6 and MMDVM Duplex as long as there is no previous solder left over from an OLED screen.
The clearance between the fan shim (not included) and most radio boards is very slim and not all boards will work with the fan shim if there are components or solder points above the fan.
The fan shim does NOT work with the N5BOC Lonestar Board***
Made at our shop in the state of Washington, USA!
C4LABS IS DEDICATED TO PROVIDING THE VERY BEST CASES AND CUSTOMER SERVICE IN THE INDUSTRY